EasyManua.ls Logo

IDEAL EVOMAX 2 Series

IDEAL EVOMAX 2 Series
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
When replacing any part on this appliance, use only spare parts that you can be assured conform to
the safety and performance specification that we require. Do not use reconditioned or copy parts that
have not been clearly authorised by Ideal.
For the very latest copy of literature for specification and maintenance practices visit our website
www.idealcommercialboilers.com where you can download the relevant information in PDF format.
USER GUIDE
EVOMAX 2
30 40 60 80 100 120 150
30P 40P 60P 80P 100P 120P
August 2019
UIN 219417 A02
Question and Answer IconNeed help?

Do you have a question about the IDEAL EVOMAX 2 Series and is the answer not in the manual?

IDEAL EVOMAX 2 Series Specifications

General IconGeneral
ModelEVOMAX 2 Series
CategoryBoiler
Fuel TypeNatural Gas
Boiler TypeCondensing
InstallationWall-mounted
Heating Capacity40kW, 60kW, 80kW, 100kW, 120kW, 150kW

Summary

Introduction and Safety

Safety Guidelines

Guidelines for safe operation and installation, emphasizing qualified personnel.

Electricity Supply Requirements

Details the required voltage, frequency, and fuse for the appliance's power connection.

Important Operational Notes

Crucial operational and safety points, including casing, clearances, and flammable materials.

Minimum Clearances for Servicing

Specifies required air gaps around the boiler for proper ventilation and servicing.

Boiler Operation and Controls

Control Panel Diagram

Visual representation of the boiler's control panel and its components.

To Light the Boiler

Step-by-step instructions for initiating the boiler's operation and ignition sequence.

Operating Status Displays

Displays of the boiler's current operational state, configuration, and system status.

System Settings and Configuration

Heating Circuits Configuration

Options to configure heating circuits, covering operating modes, temperatures, and schedules.

DHW Circuits Configuration

Settings for Domestic Hot Water (DHW) circuits, including operating modes and tank temperature control.

Installer Connections and Wiring

Mains Voltage Connections

Details for connecting the primary 230V 50Hz power supply and auxiliary outputs.

Volts Free Contacts

Configuration of multi-function relay outputs for pumps, indications, and fault signals.

PELV Connections

Low voltage connections for pump control, OpenTherm, and optional sensors like room temperature.

Troubleshooting Faults and Errors

Hardware Faults

Lists error types, descriptions, and codes for hardware-related faults like thermistors and sensors.

Temperature Supervision Faults

Details faults related to temperature monitoring, overheat conditions, and gradient supervision.

System Faults (Flame, Fan, Hydraulic)

Covers faults related to the combustion system, fan operation, and water flow.

Internal System Faults

Lists faults related to internal system operations, programming, and parameter settings.

General Information and Maintenance

Boiler Shutdown and Relighting Procedures

Procedures for safely shutting down and restarting the boiler for short or long periods.

Frost and Overheat Protection Features

Explains the boiler's built-in protection mechanisms against freezing and overheating.

Condensate Drain System Management

Details on the condensate trap and instructions for clearing blockages or frozen pipes.

Gas Leak Safety and Cleaning Instructions

Safety advice for gas leaks and instructions for routine cleaning of the boiler unit.

Related product manuals