How to fix no central heating or hot water in my IDEAL Project Heat 15?
If your IDEAL Boiler isn't providing central heating or hot water, first check that the mains switch (fused spur) is turned on and the mode control knob is in the ON position. Also, verify that the timer settings are correct and adjust them as needed.
What should I do if my IDEAL Boiler resets 5 times in 15 minutes?
If your IDEAL Boiler resets 5 times within 15 minutes, turn the power off and then on again at the fused spur. If the boiler still fails to operate, further assistance is needed.
What to do if my IDEAL Boiler has an ignition lockout?
If your IDEAL Boiler is experiencing an ignition lockout, first check if other gas appliances in your home are working to ensure there's a gas supply. If other appliances aren't working or you don't have any, check that the gas supply is turned on at the meter and/or the pre-payment meter has credit. If the boiler still fails to operate after these checks, further assistance is needed.
What to do for a Fan Fault on an IDEAL Boiler?
If your IDEAL Boiler indicates a Fan Fault, reset the appliance. If the boiler fails to operate, further assistance is needed.
How do I fix a Flow Thermistor issue on my IDEAL Project Heat 15?
If your IDEAL Boiler is showing a Flow Thermistor issue, reset the appliance. If the boiler fails to operate, further assistance is needed.
What to do if my IDEAL Project Heat 15 shows an Outside Sensor Failure?
If your IDEAL Boiler indicates an Outside Sensor Failure, reset the appliance. If the boiler fails to operate, further assistance is needed.
How to resolve a False Flame Lockout on an IDEAL Boiler?
If your IDEAL Boiler experiences a False Flame Lockout, reset the appliance. If the boiler fails to operate, further assistance is needed.
What to do if there is no water flow in my IDEAL Boiler?
If your IDEAL Boiler has no water flow, further assistance is needed.
General| Output Power / Central Heating Max Output | 15 kW |
|---|---|
| Efficiency | 93% |
| Height | 700 mm |
| Width | 400 mm |
| Depth | 250 mm |
| Mounting | Wall Mounted |
| ERP Rating | A |
| Operating Pressure | 3 bar |
| Max Water Temperature | 80°C |
| Dimensions | 700 x 400 x 250 mm |
To Next Page
