To Next PageTo Next PageWhat to do if my IDEAL Logic Heat 30 Boiler has no central heating or hot water?
If your IDEAL Boiler isn't providing central heating or hot water, first, make sure the mains switch (fused spur) is turned on and the mode control knob is in the ON position. Also, check the time settings on the timer and adjust them if needed. If a '0' is displayed, contact a Gas Safe Registered Engineer (or a Registered Gas Installer in IE).
General| Output Rating | 30 kW |
|---|---|
| Dimensions | 700 x 395 x 278 mm |
| ErP Rating | A |
| Warranty | 7 years |
| Mounting | Wall Mounted |
| Fuel Type | Natural Gas |
| Boiler Type | Combi |
Overview of the Logic Heat boiler, its features like spark ignition and fan assisted combustion.
Essential safety information, including Gas Safety regulations and electrical supply requirements.
Key points for safe operation, such as casing seal and compartment usage.
Required clearances around the boiler for installation and servicing.
Step-by-step instructions for lighting the boiler.
Instructions on how to reset the boiler.
How to adjust the central heating radiator temperature.
Procedures for turning the boiler off and on again.
Information on built-in protection against frost and overheating.
Details about the condensate drain and potential blockages.
Guidance for identifying and resolving common heating or hot water issues.
Descriptions of different display codes indicating boiler status.
List of fault codes, their descriptions, and recommended actions.
