To Next PageTo Next PageWhat to do if there is no hot water from my IDEAL Boiler?
To address the issue of no hot water with your IDEAL Boiler: * First, ensure that the mains power is on and that the control knob (B) is correctly positioned. * Next, verify that the boiler program is set to the 'ON' position and that the water cylinder thermostat is adequately turned up.
General| Boiler Type | System |
|---|---|
| Model | Logic+ SYSTEM 30 |
| Output | 30 kW |
| Dimensions (H x W x D) | 700 x 395 x 278 mm |
| Fuel Type | Natural Gas |
| Warranty | 7 years |
| ERP Rating | A |
| Mounting | Wall-mounted |
| Max Working Pressure | 3 bar |
| Central Heating Flow Temperature Range | 30-80°C |
| Efficiency Rating | ErP A-rated |
Crucial safety information, regulations, and boiler placement guidelines.
Instructions for wall preparation, mounting, and flue system setup.
Procedures for initial checks, safety tests, and starting the boiler.
Guidance on demonstrating boiler operation and providing information to the user.
Overview of fault codes and diagnostic steps for troubleshooting.
Resolving issues like ignition failure, flame loss, and water pressure problems.
Documents for recording installation compliance and service history.
Steps for users to diagnose and resolve common issues and understand fault codes.
