To Next PageTo Next Page
Need help?Do you have a question about the IDEAL LOGIC+ SYSTEM2 S30 and is the answer not in the manual?
General| Output Rating | 30 kW |
|---|---|
| Fuel Type | Natural Gas |
| Efficiency | 94% |
| Dimensions (H x W x D) | 700 x 395 x 278 mm |
| Mounting | Wall-mounted |
| ERP Rating | A |
| Central Heating Output | 30 kW |
| Max Working Pressure | 3 bar |
| Warranty | 7 years |
Steps for restarting the boiler.
Precautions and guidelines for safe handling of the boiler.
Guidance on ensuring an adequate and safe gas supply to the boiler.
Guidelines for making safe and compliant electrical connections to the boiler.
Steps for commissioning and testing the boiler's electrical and gas installations.
Procedure for the initial lighting and startup of the boiler.
Steps for restarting the boiler in case of an ignition lockout.
Recommended schedule and procedures for boiler servicing.
Instructions for replacing the primary PCB, including model setup.
Accessing fault finding information and contact details.
Troubleshooting steps for an overheat lockout fault.
Troubleshooting steps for ignition lockout faults.
Troubleshooting for flame appearing before the gas valve operates.
Troubleshooting steps when there is no central heating operation.
Troubleshooting steps when there is no domestic hot water operation.
Troubleshooting steps when the boiler display shows no output.
Record for commissioning and warranty validation of the boiler.
Checklist for gas boiler system commissioning and warranty validation.
Flowchart for checking CO levels and combustion ratios during commissioning.
Information on safety regulations for appliance installation and use.
General troubleshooting for no hot water, heating, or both.
Troubleshooting for overheat lockout fault.
Troubleshooting for ignition lockout fault.
Troubleshooting for outside sensor fault.
Troubleshooting for room thermostat fault.
Troubleshooting for gas valve fault.
Troubleshooting for return thermistor fault.
Troubleshooting for blocked flue or condensate issues.
Troubleshooting for flame loss fault.
Troubleshooting for fan fault.
Troubleshooting for no water flow fault.
Troubleshooting for too many restarts fault.
Troubleshooting for PCB fault.
Troubleshooting for pump rotor blocked fault.
Troubleshooting for flame on before gas valve on.
Troubleshooting for low mains voltage.
Troubleshooting for pump dry run.
Troubleshooting for flow thermistor fault.
Troubleshooting for low water pressure.
