Practical Guide for Sample Program of the
Barcode Reader Connection
Let’s Connect an
Operator Interface to a
Barcode Reader!
This text introduces an example of a system that imports barcode data captured by a barcode reader
into an operator interface, displaying imported data on the operator interface, and determining
OK/NG judgments.
Please open the O/I data “BCR2_BASIC_EN” and “BCR_ADVANCE_EN” stored in this Demo
version CD with the associated application software. Then, check the details of each program and
settings of this sample program while referring to the descriptions in this text. Display and entry area
of barcode number STORED/ COMPARE DATA Display and entry area of barcode number
STORED/ COMPARE DATA
Note that the data of O/I stored on this Trial Version CD is a sample and that proper operation is not
guaranteed by IDEC IZUMI.
Note: Direct connection of a barcode reader to an operator interface is supported by O/I Screen
Creation Software “WindO/I-NV2” Ver. 2.7 and later.
1
Publication date Version Revision history
Feb. 1, 2005 Ver.1.00 First edition
To Next Page
Need help?
General
