Idex GX300 - Easy-To-Solve Errors; Clamp Plate Errors; Inverter Errors

25
Troubleshooting
GX300
5.4.1 Easy-to-solve errors
5.4.2 Clamp plate errors
Problem
Possible cause
Possible solution
The display shows 'E40'
Home sensor not found.
Restart the machine. See § 3.2.13.
The display shows 'E41'
Top of clamp plates is not reached
in time.
Restart the machine. See § 3.2.13.
The display shows 'E42'
Clamp plate is sticking on can.
Cradle lock is stuck.
Restart the machine. See § 3.2.13.
The display shows 'E43'
Clamp plate is stuck in up position.
Cradle lock is stuck.
Restart the machine. See § 3.2.13.
5.4.3 Inverter errors
Problem
Possible cause
Possible solution
The display shows 'E01'
The door is open.
Close the door.
The display shows 'E05'
The cradle lock failed to release
the cradle.
Restart the machine. See § 3.2.13.
The display shows 'E08'
Emergency stop switch is pushed
during Idle/Running state.
Release the emergency stop switch. See
§ 3.2.12.
The display shows 'E48'
The mixer motor is blocked.
Push the Stop/Up key.
The display shows 'E38'
No Encoder is detected
Restart the machine. See § 3.2.13.
The display shows 'E39'
No Clamp Current
Restart the machine. See § 3.2.13.
The display shows 'E47'
Clamp plates sticking
Restart the machine. See § 3.2.13.
Problem
Possible cause
Possible solution
The display shows 'E50'
Inverter is in error mode.
Restart the machine. See § 3.2.13.
The display shows 'E51'
Failed to initialize inverter.
Restart the machine. See § 3.2.13.
The display shows 'E54'
Failed to run the mixer motor
forward.
Restart the machine. See § 3.2.13.
The display shows 'E55'
Failed to run the mixer motor
backward.
Restart the machine. See § 3.2.13.
The display shows 'E56'
Failed to stop the mixer motor.
Restart the machine. See § 3.2.13.
The display shows 'E57'
Failed to brake the mixer motor.
Restart the machine. See § 3.2.13.
The display shows 'E58'
Failed to stop braking the mixer
motor.
Restart the machine. See § 3.2.13.
The display shows 'E60'
Failed to send parameter to
inverter.
Restart the machine. See § 3.2.13.
The display shows 'E61'
Failed to send home command to
inverter.
Restart the machine. See § 3.2.13.