DOC No: PN 86880 REV A
8
LIMITS OF USE
The EagleDrive motor is intended for use with pumps handling uids in a variety
of pump ing systems. These uids may be innocuous or hazardous, depending on
the specic application. You should contact your local Micropump distributor or
contact Micropump directly about special limitations of your pump/motor unit
with regard to your specic system.
To achieve optimum performance and safe operation Micropump products must
be operated with the limits given in the Technical Specication. Operation
outside these limits is not recommended and may result in damage to the pump,
motor, and/or ancillary equipment.
Temperature. Operating beyond the maximum operating temperature
given in the Technical Specication is not recommended and may
result in damage to the product and compromise safety by creating
high surface temperature.
Mechanical Danger. The product must be installed in a location that
exposes it to a low risk of external damage.
Hot Surfaces. Under some operating conditions, surface temperatures
can exceed 90°C (195°F.) Do not touch products while operating. Do not
touch within 30 minutes of system shutdown to allow surfaces to reach
safe handling temperature.
Flooding and Water Immersion. The products covered by this guide are
not designed to operate immersed in water. Refer to the Technical
Specication for the environmental rating.
Corrosive Liquids. Corrosive liquids may eventually produce leak
paths around the sealing surfaces of the product. The product should
be inspected for leaks on a regular basis.
Condensation. When pumping cold liquids ensure that condensation
does not present a safety hazard. Condensation on the external
surfaces of the magnet cup may result in a short-circuit in the motor
controller.
To Next Page
Loading...
Need help?
General
