Need help?Do you have a question about the Idexx Filta-Max xpress and is the answer not in the manual?
General| Category | Laboratory Equipment |
|---|---|
| Manufacturer | IDEXX |
| Application | Water Testing |
| Method | U.S. EPA Method 1623 and 1623.1; USEPA Long Term 2 Enhanced Surface Water Treatment Rule (LT2) requirements |
| Compatibility | IDEXX Legiolert, Enterolert, Pseudalert, Colilert-18, Colisure, Quanti-Tray, and Quanti-Tray/2000 |
| Regulatory Compliance | U.S. EPA Method 1623 and 1623.1; USEPA Long Term 2 Enhanced Surface Water Treatment Rule (LT2) requirements |
Essential safety instructions for operating the Filta-Max xpress Pressure Elution Station.
Lists regulatory standards and certifications applicable to the product.
Visual identification of the main parts of the Pressure Elution Station.
Identifies buttons and indicators on the control panels.
Details dimensions, pressure, voltage, and operating environment.
Lists required items not supplied by IDEXX and available items.
Instructions for unit placement and connecting the power supply.
Steps for connecting the compressed air supply to the station.
Guide for setting up the equipment for sample collection.
Recommended operating pressures for effective sample flow.
Steps to assemble the filter housing and perform sample filtration.
Instructions for preparing the necessary buffer solution for elution.
Guidance on filling the buffer reservoir bottles for the system.
Procedure to verify system functionality before sample elution.
How to move a Filter Module to a compatible housing.
Explanation of buttons and operations on control panels.
Specifies equipment needed for concentrating eluates via centrifugation.
Settings for the centrifuge to properly concentrate sample eluates.
Steps for aspirating supernatant and performing a second centrifugation.
Instructions on how to resuspend the concentrated sample pellet.
Cleaning procedures to perform immediately after each elution.
Daily cleaning tasks and monthly procedures for the station.
Specifications and construction materials for the filter housing.
Details on red and black capped filter modules, including pore size.
Information on fittings for sampling and elution connections.
To Next Page
