B-1
B Using the SNAPshot Dx
*
Analyzer
Overview
The SNAPshot Dx Analyzer is controlled via a touch-screen monitor on the front of the analyzer and
by the IDEXX VetLab* Station.
Using the Touch Screen
To get the best results when using the touch screen:
• Do not rest your hand on the touch screen. The screen is sensitive to touch; pressure from
your hand prevents the touch screen from functioning properly.
• Tap the screen firmly.
• Never tap the touch screen with a sharp or abrasive object.
The touch screen is on whenever the analyzer is on.
Loading a SNAP* Test
The proper way to load a SNAP test device into the analyzer is horizontally, sample well end first. Do
not insert the SNAP device into the SNAPshot Dx Analyzer until the SNAPshot Dx Analyzer is ready
to process the device.
Important: Do not remove a SNAP test from the analyzer during analysis—removing the device
prematurely may result in loss of the run. Analysis is complete when the patient’s name is moved
from the In Process list to the Results list.
Running a SNAP* Test
For detailed instructions on running a specific SNAP test, see the “SNAP Test Procedures” chapter
in this guide.
IMPORTANT: Do not load a SNAP device until prompted by the analyzer.
To Run a SNAP Test
1. Enter the patient information on the IDEXX VetLab Station (for more information, see the
“Analyzing Samples” chapter of the IDEXX VetLab Station Operator’s Guide).
2. Once the patient’s name appears in the Pending list on the SNAPshot Dx Home screen, tap
the patient’s name and then tap Select.
3. Follow the on-screen instructions for preparing, incubating (SNAP Total T
4
and Cortisol only),
and loading the SNAP test.
When analysis is complete, the patient’s name moves from the In Process list to the Results
list (you may also receive a “New Results” alert message and/or hear a beep on the IDEXX
VetLab Station, depending on the option(s) you selected in the New Results Alert tab on the
IDEXX VetLab Station’s Settings screen). You can then remove the SNAP device from the
analyzer by gently pushing the SNAP device until you hear a click. The device will slide out of
the port.
To Next Page
Loading...
Need help?
General
