D-2
Adjusting the Volume of the Analyzer
The Sound feature on the Settings screen allows you to adjust the volume of the sounds the
analyzer emits.
Note: If you do not wish to hear any analyzer sounds, select the Mute check box.
To Adjust the Volume
1. Tap Settings on the SNAPshot Dx Home screen.
2. Tap Sound.
3. Tap the left arrow to decrease the volume or the right arrow to increase the volume. The
analyzer plays a sample of that particular volume upon each tap.
4. Tap Save.
Deleting a Patient from the Pending or In Process List
The Tools screen is available from the Home screen and provides options for editing the
Pending and In Process lists. You can edit these lists by deleting a patient from the list.
To Delete a Patient from the Pending List
1. Tap Tools.
2. Tap Edit Pending.
3. Tap to select the patient you want to remove from the Pending list.
4. Tap Delete in the Delete From Pending box.
To Delete a Patient from the In Process List
You can also delete a patient from the In Process list by selecting the patient in the In Process
list (on the SNAPshot Dx Home screen) and then tapping Stop Run in the Home screen’s center
display area.
1. Tap Tools.
2. Tap Edit In Process.
3. Tap to select the patient you want to remove from the In Process list.
4. Tap Delete in the Delete From In Process box.
5. Remove the SNAP device from the applicable port. If you accidentally remove the wrong
SNAP device, you will need to run a new SNAP Test for that patient.
Note: The IDEXX VetLab* Station displays the “New Results” alert even though no results exist for
the deleted patient run (this message only displays if you’ve selected to receive a message with new
results in the New Results Alert tab on the IDEXX VetLab Station’s Settings screen).
Modifying the Settings on the Analyzer
To Next Page
Loading...
Need help?
General
