Idis DR-2516P - Page 64

Part 2 - Conguration
64
Monitoring Options
System
Dene monitoring times. If self-
diagnosis is not performed on a
regular basis, the system will assume
an error.
Bootup,
Restart,
Shutdown
Dene bootup, restart and
shutdown actions.
Panic Record Dene panic recording actions.
Check
Recording
The system will assume an error if
the system has been scheduled to
record normally but recording does
not take place during scheduled
intervals.
Select Schedule On and then
congure the days of the week,
times, and monitoring interval.
Select the button on the
bottom left of the screen to add
a schedule. Select icon to
delete the schedule.
Check Alarm-
In
The system will assume an error if
the alarm-in status does not change
during the specied monitoring
interval while alarm-in is active.
Disk Almost
Full
Generates an event if the disk
reaches the specied capacity (80%
to 99%).
Disk Full
Generates an event when all disks
reach their maximum capacity.
Disk Partially
Almost Full
Generates an event when a disk
in one of multiple quota groups
reaches the specied capacity (80%
to 99%).
Disk Partially
Full
Generates an event when a disk
in one of multiple quota groups
reaches the specied capacity.
Disk Bad
Generates an event when the
specied percentage of the disk
becomes damaged. Set to between
10% and 90% in 10% intervals.
Disk
Temperature
Specify the threshold temperature.
Once any disk reaches this threshold,
the system will issue an alert.
Disk
S.M.A.R.T.
Monitors disks that support
S.M.A.R.T. and noties the user if a
disk error is detected.
Fan Error
Noties the user when the fan inside
the system malfunctions.
Storage
Disconnected
Noties the user if the storage
becomes disconnected while in use.
Disk Cong
Change
It will be highlighted when the NVR
reboots after the hard disk drive has
been replaced.
No Storage
Found
It will be highlighted when no hard
disk drive has been connected.
Consecutive
Invalid PW
It will be highlighted when login
fails by entering a wrong password
for consecutive attempts.
RAID BROKEN
It will be highlighted when the
mirroring conguration is broken.
(DR-2504P-A model only)
Degrade
It will be highlighted when one of
the HDDs composing mirroring is in
error. (DR-2504P-A model only)
• For system events, only an e-mail notication of
actions can be selected.
• In order to use the Notify(Callback) feature, the
NVR must be registered to the remote program on
the receiving PC's end.
• For more information on RAID Broken and
Degrade, refer to the Mirror Conguration Error
on page 42.