IDS 816 User Manual

IDS816 User Manual 700-283-01H Issued January 2009
10
6.
6. 6.
6. Arming the Control Panel
Arming the Control PanelArming the Control Panel
Arming the Control Panel
6.1
6.1 6.1
6.1 Away Arm
Away ArmAway Arm
Away Arm
[#] [USER CODE]
(Leave via Entry/Exit zone)
1. Ensure that the READY indicator is on. If not, check that all protected doors and windows are
closed and that all movement has ceased in areas covered by motion detectors. If necessary,
close the front door.
2. Press the [#] key.
3. Enter a valid [USER CODE]. If an incorrect code is entered, the keypad buzzer will beep three
times. In the event of an error press the [#] key and re-enter the code.
4. The ARMED indicator will come on and the keypad buzzer will beep repeatedly for the duration of
the exit delay. Any bypassed zones will be indicated by a steady on zone indicator.
5. Leave only via a designated exit route (leaving by any other can set off the alarm). The panel will
arm at the end of the exit delay.
6.2
6.2 6.2
6.2 Quick Away Arm
Quick Away ArmQuick Away Arm
Quick Away Arm
Hold down the [1] key until the beep
If this function is enabled, it is possible to AWAY arm by simply holding down the [1] key until the keypad
buzzer sounds and the arming process begins.
NOTE:
If the partition is already STAY armed, this key will initialise AWAY arming. It is therefore possible to
change directly from STAY armed to AWAY armed.
6.3
6.3 6.3
6.3 Stay Arm
Stay ArmStay Arm
Stay Arm
Stay arming allows the user to monitor selected perimeter zones and bypass interior zones. The user can
remain on the premises with access to designated areas during the STAY ARM cycle. Any zone that may
be violated accidentally should be programmed as a BUZZ ZONE. When violated, a BUZZ ZONE will
cause the keypad buzzer to sound for thirty (30) seconds before sounding the siren. Entering a valid
USER CODE before the siren sounds will silence the keypad buzzer and prevent the siren from sounding.
To provide greater flexibility the panel caters for the programming of two different STAY
PROFILES. Each STAY PROFILE contains a unique combination of STAY, BUZZ and ALARM zones that
caters for a particular STAY ARM requirement.
Example:
PROFILE 1 might be used when the family goes to bed in the evening. In this profile, some interior zones
may be programmed as alarm zones or buzz zones, whereas PROFILE 2 is used while watching
television when all interior zones would be bypassed.
(See How to Select a Stay Profile, under Stay Zones)

IDS 816 Specifications

General

Brand	IDS
Model	816
Category	Keypad
Language	English