IDS816 User Manual 700-283-01H Issued January 2009
12
6.5
6.5 6.5
6.5
Key
KeyKey
Key-
--
-s
ss
switch or Remote Arming (If F
witch or Remote Arming (If Fwitch or Remote Arming (If F
witch or Remote Arming (If Fitted)
itted)itted)
itted)
1. Ensure that the READY indicator is on before leaving.
2. Leave and close the door (remembering to lock!)
3. Activate the remote or the key-switch. (A remote can be used to Stay Arm or Away Arm.) The panel
will arm in the away mode.
NOTE:
If a remote control is used it is advisable to have the siren toot on arm function enabled. This provides
verification that the system has armed. (Speak to your installer about this feature)
6.6
6.6 6.6
6.6
Auto Arm
Auto ArmAuto Arm
Auto Arm
The panel may be programmed to arm automatically at a pre-programmed time. Should the premises be
occupied at the time of auto-arming, a valid user code entered during the pre-arm delay will terminate the
arming sequence. The pre-arm delay is signalled by an exit beep.
7.
7. 7.
7.
Disarming the Control Panel
Disarming the Control PanelDisarming the Control Panel
Disarming the Control Panel
7.1
7.1 7.1
7.1
How to Disarm
How to DisarmHow to Disarm
How to Disarm with a
with a with a
with a U
UU
User
ser ser
ser C
CC
Code
odeode
ode
[#] [USER CODE]
1. Enter the premises through a designated entry route. Entering via any other route will cause an
alarm.
2. As soon as the Entry/Exit zone is violated, the entry delay will begin. The keypad buzzer will sound
for the duration of the entry period.
3. Press the [#] key and enter a valid [USER CODE].
4. Once the system disarms, the ARMED indicator will turn off and the keypad buzzer will stop
sounding.
5. If no valid user code has been entered prior to the expiry of the entry delay period an alarm
condition will be registered.
6. If the entry period is too short, have your installer change the entry delay period.
NOT
NOTNOT
NOTE
EE
E:
: :
:
If a strobe (or flashing light) has been installed and an alarm condition is registered, the strobe will
continue flashing after the siren has stopped sounding. Entering a valid user code will cancel the strobe.
7.2
7.2 7.2
7.2
How to
How to How to
How to D
DD
Di
ii
isarm
sarmsarm
sarm
U
UU
Using a Key
sing a Keysing a Key
sing a Key-
--
-s
ss
switch or Remote
witch or Remotewitch or Remote
witch or Remote
1. Activate the remote or key-switch.
2. The system will disarm and the remote indicator (if installed) will turn off. If the siren toot on disarm
option is enabled, the siren will provide a double toot when the panel is disarmed
NOTE:
Speak to your installer about activating this feature.
To Next Page
Loading...
Need help?
General
