IEI Technology 212eM User Manual

Command/Action Keys to Enter/Details
Command 60.
Add/Modify Enhanced
User
60 # type # location # code * code *
(codes can be from 1 to 10 digits in length)
User Types
0 - Toggle User
1-StandardUser
3 - Lockout User
5 - Single Use Code
7 - Emergency User
8-DuressUser
9 - Two-Part User Type A
10 - Two-Part User Type B
Toggle User A toggle user latches the virtual lock output.
Standard User
Activates the virtual lock output using the lock
duration programmed with command 11.
Lockout User
This user type locks out users in user locations
higher than the lockout user when the lockout
user code is entered. For example, if the lockout
user is programmed for user 20, any user in
location 21 to 120 is locked out and their codes
no longer work to gain access. A lockout is
removed by entering the same lockout code. If
another lockout code in another user location is
entered, the lockout user location level is set to
the new lockout user location. The master code
and emergency users can not be locked out.
The current lockout is cleared when program
mode is entered. “Lockout activated” is indicated
by two double beeps. “Lockout canceled” is
indicated by one double beep.
“Access denied due to lockout” is indicated by 1
long beep followed by 3 short beeps.
“User lockout” can be enabled or disabled with
command 30.
Single Use Code
This code can only be entered once to gain
access using the lock virtual output. Once used,
this code is no longer active. A single use code
can be verified by entering 5 # code *. If the
code is a single use code, the green LED flashes
for ½ a second. An “invalid code” is indicated by
3 quick beeps.
Emergency User
This user type is a standard user that can not be
locked out by a lockout user.
IEI 212eM/242eM Standalone Installation/Programming Manual
Document # 6174000, Rev. 1.1 21

IEI Technology 212eM Specifications

General

Brand	IEI Technology
Model	212eM
Category	Keypad
Language	English