9
2. Attach a Stabilizer Foot (50) to a Base (1) with
two M4 x 19mm Screws (82).
Next, orient a Base Foot (51) as shown.
Attach the Base Foot (51) to the Base (1) with
two M4 x 19mm Screws (82).
Then, insert four M10 x 65mm Carriage Bolts
(83) upward through the Base (1). Apply tape
over the bolt heads to hold them in place.
Repeat this step with the other Base (1).
Make sure that the Base Foot (51) is oriented
as shown.
2
1
1
82
51
51
82
50
83
83
3. Insert two M10 x 65mm Carriage Bolts (83)
upward through the Center Base (2). Place tape
over the bolt heads to hold them in place.
83
2
3
To Next Page
Loading...
