EasyManua.ls Logo

IFM Electronic AL1900 - Page 3

IFM Electronic AL1900
90 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
ifm Device Manual IO-Link Master with PROFINET interface CabinetLine 8 Ports IP 20 (AL1900) 05 / 2018
Content
8 Configuration 23
8.1 LR DEVICE ........................................................................................................................24
8.1.1 Remarks ..................................................................................................................................... 25
8.1.2 IoT: Configure access rights ....................................................................................................... 26
8.1.3 IoT: Configure IP settings ........................................................................................................... 27
8.1.4 IoT: Configure the interface to the LR SMARTOBSERVER ....................................................... 28
8.1.5 Fieldbus: Configure the PROFINET port .................................................................................... 28
8.1.6 IO-Link ports: Activate data transfer to the LR SMARTOBSERVER .......................................... 28
8.1.7 IO-Link ports: Configure operating mode.................................................................................... 30
8.1.8 IO-Link ports: Set the device validation and data storage .......................................................... 31
8.1.9 Firmware: Reset device to factory settings ................................................................................. 32
8.1.10 Firmware: Reboot the device ...................................................................................................... 32
8.1.11 Configure IO-Link devices .......................................................................................................... 33
8.2 PROFINET .........................................................................................................................34
8.2.1 Install GSD file ............................................................................................................................ 35
8.2.2 Add the IO-Link master to the PROFINET network .................................................................... 36
8.2.3 Configure access rights .............................................................................................................. 38
8.2.4 Configure IO-Link ports .............................................................................................................. 39
8.2.5 Configure the PROFINET port .................................................................................................... 40
8.2.6 Configure IO-Link devices .......................................................................................................... 40
8.2.7 Read and write data cyclically .................................................................................................... 41
8.2.8 PROFINET: Read & write device information ............................................................................. 41
8.2.9 PROFINET: Programmers' notes ............................................................................................... 42
8.3 IoT Core .............................................................................................................................44
8.3.1 Configure IoT interface ............................................................................................................... 45
8.3.2 Configure the fieldbus interface .................................................................................................. 45
8.3.3 Configure IO-Link ports .............................................................................................................. 46
8.3.4 Configure IO-Link devices .......................................................................................................... 46
8.3.5 Set application identification ....................................................................................................... 47
8.3.6 Read / write cyclic process data ................................................................................................. 47
8.3.7 Read diagnostic data .................................................................................................................. 47
8.3.8 Control IO-Link master ............................................................................................................... 48
8.3.9 Read device information ............................................................................................................. 48
8.3.10 Read information about IO-Link devices .................................................................................... 49
8.3.11 Examples .................................................................................................................................... 50
8.3.12 Programmers' notes ................................................................................................................... 54
9 Operation 58
9.1 Firmware update ................................................................................................................58
9.2 Web interface: Read device and diagnostic information....................................................59
9.3 Replace IO-Link device ......................................................................................................60
10 Maintenance 61
11 Factory settings 62
12 Accessories 63
13 Appendix 64
13.1 Technical data ....................................................................................................................65
13.1.1 Application .................................................................................................................................. 65
13.1.2 Electrical data ............................................................................................................................. 65
13.1.3 Inputs / outputs ........................................................................................................................... 65
13.1.4 Inputs.......................................................................................................................................... 66

Table of Contents