IFM Electronic SmartController CR2530 - Page 19

UK
SmartController CR2530
19
ifm electronic gmbh ● Friedrichstraße 1 ● 45128 Essen We reserve the right to make technical alterations without prior notice! 20.09.2013CR2530 / Page 7
CR2530 Output characteristics
Control systems
PWM output (PWM)
Output frequency 20...250 Hz (per channel)
Pulse/pause ratio 1...1000 ‰
Resolution 1 ‰
Switching current 0.02...2 A
OUT08_A...09_A
Analogue outputs
Voltage range 8...32 V
Current rating < 5 mA
Output voltage 0.2...10 V
Accuracy ± 6 % FS
Residual ripple at 120 Hz 80 mV
OUT10...11
Digital / PWM outputs
Protective circuit for inductive
loads
integrated
Diagnosis wire break none
Diagnosis short circuit none
Digital output (B
H
)
Switching voltage 8...32 V DC
Switching current 0.02...4 A
PWM output (PWM)
Output frequency 20...250 Hz (per channel)
Pulse/pause ratio 1...1000 ‰
Resolution 1 ‰
Switching current 0.02...4 A
OUT12...15
Digital outputs
Protective circuit for inductive
loads
integrated
Diagnosis wire break none
Diagnosis short circuit none
Digital output (B
H
)
Switching voltage 8...32 V DC
Switching current 0.02...2 A
Load current per output group
(VBB
1
, VBB
2
)
≤ 12 A
(for continuous operation ≤ 9 A; i.e. operation ≥ 10 min)
Overload protection
(valid for all outputs)
max. 5 minutes (at 100% overload)
Short-circuit strength to GND switch-off of the outputs is carried out via the output driver