IFM Electronic SmartController CR2530 - Output Characteristics

SmartController CR2530
18
7.4 Output characteristics
ifm electronic gmbh ● Friedrichstraße 1 ● 45128 Essen We reserve the right to make technical alterations without prior notice! 20.09.2013CR2530 / Page 6
CR2530 Output characteristics
Control systems
OUT00...01
Digital / PWM outputs
Protective circuit for inductive
loads
integrated
Diagnosis wire break via voltage feedback
Diagnosis short circuit via voltage feedback
Diagnosis excessive current integrated
Digital output (B
H
)
Switching voltage 8...32 V DC
Switching current 0.02...2 A
PWM output (PWM)
Output frequency 20...250 Hz (per channel)
Pulse/pause ratio 1...1000 ‰
Resolution 1 ‰
Switching current 0.02...2 A
Current-controlled output (PWM
I
)
Output frequency 20...250 Hz (per channel)
Control range 0.02...2 A
Setting resolution 1 mA
Control resolution 2 mA
Load resistance ≥ 6 Ω (at 12 V DC)
≥ 12 Ω (at 24 V DC)
Accuracy ± 1.5 % FS
OUT02...07
Digital / PWM outputs
Protective circuit for inductive
loads
integrated
Diagnosis wire break only if switched off
U
OUT
> 27.5 % VBB
S
Diagnosis short circuit only in the logic ON state
U
OUT
< 93.5 % VBB
S
Digital output (B
H
)
Switching voltage 8...32 V DC
Switching current 0.02...2 A
PWM output (PWM)
Output frequency 20...250 Hz (per channel)
Pulse/pause ratio 1...1000 ‰
Resolution 1 ‰
Switching current 0.02...2 A
OUT08...09
Digital / PWM outputs
Protective circuit for inductive
loads
integrated
Diagnosis wire break none
Diagnosis short circuit none
Digital output (B
H
)
Switching voltage 8...32 V DC
Switching current 0.02...2 A