IFM Electronic SU8000 - General Parameter Setting Procedure

23
UK
10.1 Parameter setting in general
3 steps must be taken for each parameter setting:
1
Select parameter
► Press [Mode/Enter] until the re-
quested parameter is displayed.



2
Set parameter value
► Press and hold [Set]�
> Current setting value of the param-
eter flashes for 5 s�
> After 5 s: setting value is changed:
incrementally by pressing the button
once or continuously by keeping the
button pressed�



Numerical values are incremented continuously� For reducing the value:
► Let the display move to the maximum setting value�
> Then the cycle starts again at the minimum setting value�
3
Acknowledge parameter value
► Briefly press [Mode/Enter]�
> The parameter is displayed again�
The new setting value is saved�



Set other parameters
► Start again with step 1�
Finish parameter setting and change to the process value display:
► wait for 15 s
or
► press [Mode/Enter] several times until the current measured value is displayed�
> The unit returns to the operating mode�
10.1.1 Change from menu level 1 to menu level 2
► Press [Mode/Enter] until [EF] is dis-
played.



► Briefly press [Set]�
> The first parameter of the submenu is
displayed (here: [HI])�


