iGenix IG9042 - Overheat Protection Mechanism; Cleaning and Maintenance Procedures

10
CLEANING AND MAINTENANCE
Before attempting any cleaning or maintenance on the appliance, allow it to cool
completely and ensure that it is switched off and disconnected from the power
supply.
Wipe the outside of the unit with a soft, damp cloth. A mild detergent may be
used if necessary. Dry with a cloth. Do not use any harsh abrasives or solvents.
Never immerse this appliance in water or any other liquid.
If the appliance is not going to be used for a long period of time, safely
disconnect from the power socket and store the appliance in a dry place.
Note: Storing the appliance in a damp environment could cause the unit to rust
and/or could effect the electronics in the appliance.
OVERHEAT PROTECTION
This appliance is tted with a Thermostatic Cut Off that automatically switches
off the unit in case of overheating (e.g due to the appliance being covered or
obstructed). Should the appliance switch off due to overheating, the following
steps should be taken immediately:
• Switch the appliance to standby mode and safely disconnect from the power
socket.
Note: Take care in not touching the appliance, as it will be hot and may cause
injury.
• Remove anything that may be obstructing the unit.
• Wait at least 30 minutes for the appliance to cool down completely.
• Reconnect the unit to the power source and turn the appliance back on.