12
The most suitable temperature for the room during the summer varies from 24°C to 27°C (75°F
to 81°F). You are recommended, however, not to set a temperature much below the outdoor
temperature. The fan speed difference is more noticeable when the appliance is under Fan mode
but may not be noticeable under Cool mode.
Heat Mode
To set this mode correctly:
• Press the “ ” button a number of times until the Heat symbol appears.
• Select the target temperature13°C-27°C (55°F-81°F) by pressing the “ ” or “ ” button until
the corresponding value is displayed.
• Select the required fan speed by pressing the “ ” button.
• Four speeds are available: High / Medium / Low / Auto.
• Water is removed from the air and collected in the tank.
• When the tank is full, the appliance shuts down and “ ” (full tank) appears on the display. The
tank cap must be extracted and emptied. Run off all water left into a basin. When all the water
has been drained, put the cap back in place.
• When the tank has been emptied, the appliance starts up again.
NOTE: When operating in very cold rooms, the appliance defrost automatically, momentarily
interrupting normal operation. “ ” appears on the display. During this operation, it is normal for
the noise made by the appliance to change.
• In this mode, you may have to wait for a few minutes before the appliance starts giving out hot
air.
• In this mode, the fan may operate for short periods, even though the set temperature has
already been reached.
Fan Mode
When using the appliance in this mode, the air hose does not need to be attached.
• Press the “ ” button a number of times until the Fan symbol appears.
• Select the required fan speed by pressing the “ ” button.
Three speeds are available: High / Medium / Low.
The screen display will show “ ” as high speed, “ ” as medium speed, “ ” as low speed.
To Next Page
Loading...
