BEFORE YOU START
Your Bluetooth device (cellphone, MP3 player, etc.) must support the HSP, HFP, A2DP and
AVRCP Bluetooth profiles (commonly known as hands free and stereo audio profiles) to work
with the iHome iD50. Please refer to your Bluetooth device’s user manual for details on the
Bluetooth profiles it supports and on how to set the device’s Bluetooth pairing/searching mode.
ABOUT PAIRING
Pairing is the term used when wirelessly connecting two Bluetooth devices for the first time.
This allows the devices to “see” each other and creates a unique lasting connection between
the specific devices.
PAIRING & LINKING YOUR BLUETOOTH DEVICE WITH THE iD50
1) Make sure your Bluetooth device is fully charged.
2) Power up your Bluetooth device and connect your iD50 to power with the AC adaptor.
3) Turn on Bluetooth functionality on your Bluetooth device. Typically, Bluetooth controls are
found on the device’s tools or settings menu (see your user manual). Turn on Bluetooth
connectivity/make your device “discoverable”.
4) To put the iD50 in pairing mode, press and hold the EQ/Pairing button located on the top
of the unit for about 2 seconds. The Bluetooth icon and “pairing” icon on the iD50 will
flash.
5) Choose “add a new Bluetooth device” on your device. It will start to search. If the pairing
attempt fails or times out, press and hold the EQ/Pairing button on the iD50 briefly to
restart the process, and repeat “add a new Bluetooth device” on your Bluetooth device.
6) After your device and the iD50 have discovered each other, a “Pairing Successful” or similar
message should appear on your device and the Bluetooth icon on the iD50 should stop
flashing, followed by a confirmation beep. If your device prompts you for a pass code,
please enter “1234”.
7) Pairing remains intact when the iD50 and/or the Bluetooth device is powered off or is taken
out of link range (30 feet). The iD50 supports auto-linking and will automatically re-establish
an active connection when your Bluetooth device returns within range.
8) The iD50 will automatically try to re-establish a link with the most recently linked Bluetooth
device. If your device does not support auto-linking OR was not the last linked to the iD50,
you must re-link manually by selecting iD50 from the Bluetooth device’s menu on your
Bluetooth device.
Printed in China
iD50PSHEET-090211-A
QUICK BLUETOOTH CONNECTION GUIDE
iD50
10:09
Bluetooth
Off
On
Select Back
10:09
Connectivity
Infrared
Packet data
Data transfer
Bluetooth
Select Back
10:09
Bluetooth
Off
On
Select Back
10:09
Bluetooth
Off
On
Select Back
2
1
3
4
iD50 Quick connection sheet
Print color: Blue (PMS 293C), Black
Size: 184 x 165 (mm)
Mat’l: 120gsm paper
Sept. 7,11.
snooze/dimmer
mode
eq
nap
bedtime
wakeuppairing
talk
end
line-in
am antenna
DC 12V
RESET
RESET
TEST
TEST
Need help?
General
