IKA C 1 - Maintenance and Information Access; Preparing and Performing Measurements; Executing a Measurement

18
Maintenance
The following submenus are available:
• Change seal
• Test stirrer
• O
2
System blow
• Servo up
• Servo down
INFO: When performing maintenance programs, the system
must be open !
Information
The following informations are available:
• Software
• Firmware
• Serial number
• Service
• Pressure test
• Ignitions
• Next test
• Support
The term “measurements“ below refers to both the measure-
ments to calibrate the calorimeter system (calibration measure-
ments) and the actual measurements for determining the calorific
value. The difference lies mainly in the evaluation, whilst prepara-
tion and performance make virtually no difference.
Performing the measurement
Select and confirm “Measurements“ in the main menu with the
multi-function element.
In the submenu select and confirm the option “New
measurement“.
Preparing and performing measurements