Connection to the condenser
Make sure the filter casing is always se-
curely closed (see „Servicing and clean-
ing the filter“)!
Insert the inflow pipe into the „IN“
port until it clicks home. Connect the
other end of the pipe to the „OUT“
port of the condenser (water pressure
max 1.5 bar).
Insert the return pipe into the „OUT“
port until it clicks home. Connect the
other end of the pipe to the „IN“ port
of the condenser.
The connection „EMPTY“ is intended
only for emptying the device, e.g.
for transport purposes. In normal
operation the discharge hose need not
be inserted!
Rear view without hoses attached
Connection to the water
Operatrion is only allowed with the
pressure valve IKA
®
C 25!
The IKA
®
C 25 pressure valve is ab-
solutely essential on the water faucet
for operation of the calorimeter, and it
must be preset to an output pressure
of approximately 1.5 bar.
The valve is installed into the line of
the water connection, see operating
instruction IKA
®
C 25.
To Next Page
Loading...