IKA Plate - Page 12

22 23
/// Menu details
Operating mode:
Mode A:
All settings will be stored if the device is switched off or disconnected from the power supply�
The stirring and heating functions will be set to OFF when the device is powered on� The safety
circuit can be set or modified� When the power supply switch is switched on, A is displayed�
Mode B:
All settings will be stored if the device is switched off or disconnected from the power supply�
The stirring and heating functions will be set to ON or OFF when the device is powered on,
depending on the previous status of the device� The safety circuit can be set or modified� When
the power supply switch is switched on, B is displayed�
Mode D:
When switching the device on, the safe temperature has to be confirmed by pushing one of
the rotating / pressing knobs�
During operation, in mode D the device behaves the same as in Mode A with the exception
that:
› The temperature / speed setting must be confirmed by pressing the rotating / pressing knob�
To change the temperature / speed setting, turn the rotating / pressing knob until the desired
value appears�
› The new value flashes for 5 seconds on the display� Confirm the new temperature / speed
setting by pressing the rotating / pressing knob, otherwise the temperature / speed setting
value will skip back to its previous value�
Temperature control mode:
When using an external PT 1000 temperature sensor, you can choose below control modes:
PID mode:
Good control results, minimized overshooting, slow rise in temperature�
2P-mode (two-point controller):
Maximum heating rate, increased overshooting�
PI mode:
Good control results, for some of the heating blocks�
T
Set
t
PID
T
Set
t
2P
Temp. control
Factory settings
Intermittent mode /
Rotation direction
Intermittent mode
Rotation direction
Automatic reverse rotation
Run time
Pause time
00:00 [mm:ss]
00:03 [mm:ss]
Clockwise (continuous)
ON
OFF
-

Beep
ON
OFF

-
Temperature unit
°C
°F (not available for Japan)

-
Timer expired
yes
no
yes
no
Stop heating
Stop stirring
-

-

Safe / Visc
Safe
Visc

-
SAFE
Factory reset
yes
no
-

Probe calibration
(not default) reset no
yes
(default) set no
yes
2 Point

-

-
Software version
-
Error 5
05:00 [mm:ss]
Operating mode
A
B
D

-
-
Temperature control mode
PID
2P
PI

-
-
/// Menu structure