6 7
/// Permissible medium / contaminants / side reactions
Warning!
› Only process media that will not react dangerously to the extra energy produced through
processing� This also applies to any extra energy produced in other ways, e�g� through light
irradiation�
Explication of warning symbols
EU Declaration of conformity
/// Warning symbols
/// General Symbols
Note
Indicates steps of actions that require particular attention�
Position number
Indicates device components relevant to actions�
A–––
Correct / result
Indicates the correct execution or the result of an action step�
Wrong
Indicates the incorrect execution of an action step�
We declare under our sole responsibility that this product corresponds to the directives 2014/35/EU,
2006/42/EC, 2014/30/EU and 2011/65/EU and conforms with the following standards or nor-
mative documents: EN 61010-1, EN 61010-2-010, EN 61010-2-051, EN 61326-1, EN 60529
and EN ISO 12100�
A copy of the complete EU Declaration of Conformity or further declarations of conformity can
be requested at sales@ika.com�
Source language: German
Indicates an (extremely) hazardous situation, which, if not avoided, will
result in death, serious injury�
Danger!
Indicates a hazardous situation, which, if not avoided, can result in
death, serious injury�
Warning!
Indicates a potentially hazardous situation, which, if not avoided, can
result in injury�
Caution!
!
Indicates practices which, if not avoided, can result in equipment dam-
age�
Notice!
Indicates the risks due to magnetism�
Attention!
Indicates the exposure to a hot surface�
Danger!
Beep
Indicates action steps, for which beep sounds are to be heard�
/// General information
› Read the operating instructions in its entirety before using the device and follow
the safety instructions.
› Keep the operating instructions in a place where it can be accessed by everyone�
› Ensure that only trained staff work with the device�
› Follow the safety instructions, guidelines, occupational health and safety and accident
prevention regulations�
› Electrical outlet must be grounded (protective ground contact)�
Attention – Magnetism!
› Effects of the magnetic field have to be taken into account (e�g� data storage media, cardiac
pacemakers ���)�
Risk of burns!
› Exercise caution when touching parts of the housing and the heating plate�
› The heating plate can reach dangerous temperatures� Pay attention to the residual heat on
the heating plate after switching off the stirrer�
› The device may only be transported when the heating plate has cooled down�
!
Notice!
› Pay attention to the marked sites in Fig. 1�
Safety instructions
/// Device design
Danger!
› Do not use the device in explosive atmospheres, it is not EX-protected�
› With substances capable of forming an explosive mixture, appropriate safety measures must
be applied, e�g� working under a fume hood�
› To avoid body injury and property damage, observe the relevant safety and accident
prevention measures when processing hazardous materials�
Caution!
› Device surface is partially made of glass:
- Glass surface can be damaged by impact�
- If glass surface is damaged it could cause injury, don`t use the device anymore�
!
Notice!
› Set up the device in a spacious area on an even, stable, clean, non-slip, dry and fireproof
surface�
› The feet of the device must be clean and undamaged�
› Ensure that the power cord set / temperature sensor cable does not touch the heating plate�
› Check the device and accessories for damage before each use� Do not use damaged
components�
!
To Next Page
Loading...
