- 10 -
3.6 ONVIF Mode Setting
Delete Saved Device:
Move the joystick up and down to view devices. Move the joystick rightward to view the
device’s port information. Move the joystick leftward to view the IP, CAM NUM information.
Press “ENTER” to delete the selected device.
EX: Select the address: 1 > ENTER > Select the protocol: PELCO-D > ENTER > Select the baud
rate: 9600 > ENTER
When the controller is switched to address 1, the control baud rate is 9600, protocol is
PELCO-D
Search and Add
In ONVIF mode, follow the steps below to add a LAN device to the PTZ controller:
4. Connection and Control
4.1 Connection and Control in ONVIF Mode
1. After the controller has obtained IP address, simply press the SEARCH button.
2. All available devices with the ONVIF protocol in the LAN will be displayed on the controller
when search process is complete.
3. Move the joystick up/down to select the device. Press the “ENTER” button to confirm.
4. It’s required to enter the device’s username, password and CAM NUM information when
adding a device.
5. Press the “ENTER” button to save.
6. Alternatively, use the [IP] button to add a device manually.
7. Press the “INQUIRE” button to view the added device. Move the joystick up/down to view the
saved device (move the joystick rightward to view the port). Press the “ENTER” button to select
a camera to control, or use the CAM button to connect and control.
To Next Page
Loading...