Ikan OTT-CONTROLLER - VISCA & IP VISCA Mode Shared Setting; IP VISCA Mode Setting; VISCA Mode Setting; PELCO Mode Setting

- 9 -
3.2 VISCA & IP VISCA Mode Shared Setting
3.3 IP VISCA Mode Setting
3.4 VISCA Mode Setting
3.5 PELCO Mode Setting
1. F1: Custom function for F1 button (VISCA command)
2. F2: Custom function for F2 button (VISCA command)
Input custom name > ENTER > Input VISCA command
For example: If the command is 8101040702FF, then input 01040702 (0 can’t be omitted)
Delete the saved device:
Move the joystick up and down to view devices; Move the joystick rightward to view the
device’s port information; Move the joystick leftward to view the IP, CAM NUM information;
ENTER to delete the selected device.
Control Settings (set the baud rate for a certain address code):
Move the joystick up, down, left and right to switch addresses (1-7) > ENTER > Move the
joystick left and right to switch baud rate > ENTER
EX: Select the address: 1 > ENTER > Select the baud rate: 9600 > ENTER
When the controller is switched to address 1, the control baud rate is 9600
Control Settings (set the baud rate for a certain address code):
Move the joystick up, down, left and right to switch addresses (1-255) > ENTER > Move the
joystick left and right to choose protocols > ENTER > Move the joystick left and right to switch
baud rate > ENTER