IKEA LIVSLAGA - Gas and Control Adjustments; Gas Type Conversion and Injector Changes; Minimum Flame Setting Adjustment

ENGLISH 14
Makesurethattheoutletisneartheproduct
toinstall.So,ifthecablethatcamewiththe
productisnotlongenough,youwillneedto
replaceitwithanotheronehavingthesame
featuresbutwiththerightlength.
Adjustment to different type of gas
WARNING
- This operation must be performed by a
qualiedtechnician.
Iftheapplianceisintendedtooperatewith
a different gas from the gas type stated on
the rating plate and information label on
the top of the hob, change the injectors.
Removetheinformationlabelandkeepit
withtheinstructionsbooklet.
Use pressure regulators suitable for the gas
pressure indicated in the Instruction.
- Thegasnozzlesmustbechanged
byAfterSalesServiceoraqualied
technician.
- Nozzlesnotsuppliedwiththeappliance
must be ordered from After Sales
Service.
- Adjust the minimum setting of the taps.
NOTE:whenliquidpetroleumgasisused
(G30/G31),theminimumgassettingscrew
mustbetightenedasfarasitwillgo.
IMPORTANT: should you experience
difcultyinturningtheburnersknobs,
please contact the After Sales Service for
the replacement of the burner tap if found to
be faulty.
Replacing the injectors (see paragraph
“injector table”)
- Remove grids (A).
- Extract burners (B).
- Usingasocketspannerofthe
appropriatesizeunscrewtheinjector
(C),unscrewtheinjectortobereplaced.
- Replaceitwiththeinjectorsuitablefor
thenewtypeofgas.
- Re-assemble the injector in (D).
Beforeinstallingthehob,remembertoafx
thegascalibrationplatesuppliedwith
theinjectorsinsuchawaythatitcovers
the existing information relating to gas
calibration.
Adjusting minimum gas setting of taps
To ensure that the minimum setting is
correctlyadjusted,removetheknob(E)and
proceedasfollows:
- tightenscrewtoreducetheameheight
(-);
B
A
D
C
E