INITIALISATION INSTRUCTIONS:
HEIGHT ADJUSTMENT CONTROLLER
Step 1. Continuously press the button for a few seconds until the desk reaches its lowest position.
Step 2. Continuously press the button a second time until the display shows “RST”.
Step 3. Continuously press the button a third time until the desk moves slightly downwards. When the
desk stops moving and the display shows “72”, it is ready to use.
INITIALIZATION / RESET PROCESS:
Step 1: Press/hold the button for a few seconds until the table reaches its lowest position.
Step 2: Press/hold the button a second time until the display shows “RST”.
Step 3: Press/hold the button a third time until the table slowly lowers. Once the table stops moving and
the display shows “72”, your desk is ready to use.
— LED Display: Press any key once to wake up the LED display.
— Up key : Press and hold to raise the desk.
— Down key : Press and hold to lower the desk.
— Memory setting: + , , , :
— To save this current height: Press the button , the display will show “S-“, then press preferred
memory button , , , . This will bind the height to this number.
— For Example, if you press , the display will show “S-1” etc…
— Memory button , , ,
NOTE!
— The desk's movement can be stopped at any time by pressing any button.
— Height settings will remain even if the desk’s power is cut
LED Display for Actual Height Down Key Memory 2 Memory 4
Up Key Memory 1 Memory 3 Memory Setting
LOCK / UNLOCK CONTROLLER
Lock the controller: Press and hold the for 10 seconds until the display shows “LOC”.
Unlock the controller: Press and hold the symbol for 10 seconds until the display shows the actual
height of the table.
To Next Page
Loading...
