IKEA UPPSPEL - Desk Operation and Settings; Performing Basic Setting; Desk Initialisation Process; Controller Interface Overview

6
Reset process:
Step 1: Press/hold the
down button for a few seconds until the table reaches
its lowest position.
Step 2: Press/hold the
down button a second time until the display shows
“RST”.
Step 3: Press/hold the
down button a third time until the table slowly lowers.
Once the table stops moving and the display shows “72”, your desk is ready to
use.
Lock/Unlock controller:
Lock the controller: Press and hold the
symbol for 10 seconds until the
display shows “LOC”.
Unlock the controller: Press and hold the
symbol for 10 seconds until the
display shows the actual height of the table.
Error Code Instructions
Error Code Reason Solution
E01 Overcurrent protection/short circuit See instructions for Reset/Initialisation.
E07 Motor line open circuit error See instructions for Reset/Initialisation.
H01 Over-heating Unplug from the wall socket and re-plug – or wait 18 minutes to let the
motors cool before using them again.
RST Power failure See instructions for Reset/Initialisation.
888/000 Controller error Please contact IKEA Customer Service.
The crossed-out wheeled bin symbol indicates that the item should be disposed
of separately from household waste. The item should be handed in for recycling
in accordance with local environmental regulations for waste disposal. By
separating a marked item from household waste, you will help reduce the
volume of waste sent to incinerators or land-lls and minimise any potential
negative impact on human health and the environment. For more information,
please contact your IKEA store.