6
Initial Camera Setup (before placing camera in housing)
- In the Shooting Menu:
Set Metering to “Center-weighted.”
Set Continuous Mode to “S” Single.
Set AF area mode to “Center (normal).”
Set Autofocus mode to (AF-S) “Single AF.”
Set Flash exp. comp. to “0.0.”
Set Noise reduction filter to NR “Normal.”
Set Built-in ND filter to “OFF.”
Set Distortion Control and Active D-Lighting to “OFF.”
Set Startup zoom position to “28” and Focus-coupled metering to “ON.”
- In Commander mode:
Set Flash Mode to “Standard flash.”
Set Flash control mode to “TTL.”
- In Quick Menu Settings:
Set Image Quality to “FINE” and Image Size to “12m.”
Set ISO to “200.”
Set Image Size to “12m.”
Set WB White Balance to “Auto (normal): AUTO1.” For best results, set
manual white balance for each working depth.
- Set Dial to “0.”
-RAISE the Flash. Flash CANNOT be raised once the housing is closed.
Flash is disabled in Continuous Shooting and Auto Bracketing modes.
To Next Page
Loading...
