5
Initial Camera Setup (before placing camera in housing)
- Insert a fully charged battery
- Set Shooting Mode dial to “A” Aperture priority or “M” Manual. In “A”
Aperture Priority mode the shutter speed will lock at 1/30th second. If a
faster shutter speed is desired or picture blur occurs, use “M” Manual
mode. For Macro photography, set Aperture to f8 and engage “Macro
close-up” setting in the camera menu.
- In the Set up Menu:
Set Time zone and date.
Set Vibration reduction to “On.”
Set AF assist and Digital zoom to “Off.”
Set Auto off to “5m” 5 min.
Insert and Format an SDHC memory card.
Set Flash control to “Auto.”
This product has been water pressure tested at the factory and is depth
rated to 200ft (60m). Thoroughly inspect and immerse the empty
housing completely in water before installing a camera. If any fogging
occurs or droplets of water enter the housing, do not install a camera.
Clean the main housing o-ring and retest to make sure that it is
watertight. Refer to the Troubleshooting section, page 21.
Please read your camera manual thoroughly to have a full
understanding of each camera function.
If you are new to underwater photography, be sure to read the Photo
Tips section, page 20.
Preparation
To Next Page
Loading...
