ILVE ILD88B - Advanced Functions; Residual Heat and Booster Power; Timer and Automatic Cooking

9
Residual heat indication
After the heating zone is turned off, or the complete stop of the hob, the heating zones are still
hot and indicates [ H ] on the display.
The symbol [ H ] disappears when the heating zones may be touched without danger.
When theresidualheatindicatorsareon,don’ttouchtheheatingzonesanddon’tputanyheat
sensitive object on them. There are risks of burn and fire.
Booster function
The Power function [ P ] grants a boost of power to the selected heating zone.
If this function is activated the heating zones work during 10 minutes with an ultra high power.
Power is needed for example to heat up large quantities of water rapidly, like for noodles
x Start up / Stop the booster booster function:
Action Control panel Display
Zone selection Pressonthe“SLIDER“ [ 0 ] and control
across from the desired zone light on
Start up the Power Slideonthe“SLIDER“ [ 0 ] to [ P ]
Stop the Power Slideonthe“SLIDER“ [ P ] to [ 0 ]
x Power management:
The whole cooking hob is activated with a maximum limit of power. When the booster function is
activated, and in order to exceed the maximum power, the electronic system reduces the power
level of other heating zones. The display will blink on [ 9 ] for a few seconds and then shows the
maximum of power allowed:
Heating zone selected The other heating zone: (example: power level 9)
[ P ] is displayed [ 9 ] goes to [ 6 ] or [ 8 ] depending the type of zone
Timer
The timer is able to be used simultaneous with all heating zones with different time settings (from
0 to 99 minutes) for each heating zone.
x Setting and modification of the cooking time :
Action Control panel Display
Zone selection Pressonthe“SLIDER“ [ 0 ] and control
across from the desired zone light on
Select the power level Slideonthe“SLIDER“ [ 1 ] to [ 9 ]
Select « Timer » Press on the [ ] [ 00 ]
Set the tens Press on the [ ] [ 10, 20, 30, ... ]
Set the units Slide on the“SLIDER“ [ 31, 32, 33, 34, 35, ...]
The time is confirmed and the cooking starts.
x To stop the cooking time :
Action Control panel Display
Zone selection Pressonthe“SLIDER“ [ 0 ] and control
across from the desired zone light on
Select « Timer » Press on the [ ] [ 00 ]
Desactivate « Timer » Slideonthe“SLIDER“to[0] [ 00 ]