Page 6 of 14
For the Installer:
These Instructions contain important information designed to help the user obtain
the maximum benefit from the investment in an IMC MF Peeler.
Please read them carefully before starting work, and consult with the supplier in the
event of any queries.
Be sure to leave this Instruction Manual with the user after installation of the
machine is complete.
MF5 Bench installation
The MF5 is designed to stand on a bench, table, or on a draining board. DO NOT
mount or operate the unit in a sink. Ensure that whatever is used for this purpose is
sturdy and rigid and not more than 750mm high. A higher table makes it difficult to load
the machine. If the bench is sloping, or on a ship, the machine should be bolted to the
bench using four M6 x 25mm bolts and washers. All models are supplied with the waste
pipe at the back, a longer pipe is available for MF5 bench top locations. A stainless
steel stand, which includes a filter basket is available as an option.
MF5 Bench mounting points
To Next Page
Loading...
Need help?
General
