Check that the supply voltage corresponds to that showed in the license plate data (voltage tolerance ±10%,
frequency tolerance ±1Hz).
License plate data is visible on the back of the car.
For the connection use a cable of type H05 VV – F or higher sized as reported in the license plate data. The following
minimum sections are suggested:
ATTENTION!
The minimum sections listed above may vary depending on the length of the connection. For lengths longer than
5 meters, increase the section proportionally to the added length.
ATTENTION!
The connection of the machine must always be carried out according to the matricular data (power, supply
voltage, frequency). For supply voltages other than those envisaged, request information from the manufacturer.
ATTENTION!
If the power supply comes from a diesel generator, the inverter requires the application of an added inductance.
Interpose upstream of the appliance an omni polar disconnection device (e.g., a differential circuit breaker) with an
opening between the contacts that allows complete disconnection under the conditions of surge category III and follows
the relevant regulations in force. The breaking power of the circuit breaker shall be at least 10 kA.
ATTENTION!
Before switching on equipment that has undergone a thermal shock, wait for evaporation any moisture is
condensed to avoid possible damage to the electronic components.
Make sure the main switch is in the "0" position.
Open the side door using the key that is delivered with the machine documentation.
To Next Page
Loading...
