At the first achievement (after switching on) of the set temperature value, the buzzer emits some beeps, to warn the
user.
In any case, do not start the ironing work until the minimum temperature of 80 ° C is reached.
At the end of the ironing cycle, the machine must be stopped by pressing the COOL DOWN button: in this case the
machine will continue to keep the roller in rotation until it reaches 80 ° C, a temperature considered safe for the
complete shutdown by the general switch of the machinery (see the dedicated chapter).
Avoid pressing the STOP button to interrupt an ironing cycle if the safety temperature of 80°C has not already been
reached.
ATTENTION!
The machines described here should not be used to perform bending. We therefore invite you to avoid folding
the fabrics to be ironed one or more times, before introducing them into the drying calendar!
During operation it must be remembered to use the entire length of the roller, so as to maintain uniform temperature
over the entire length of the machine.
Therefore, regardless of the size of the linen, introduce the same as shown in the figure.
The temperature to be used must follow the temperatures allowed by the characteristic plates of the linen to be ironed.
Remember that at the end of the work, the machine cannot be stopped, at least until the temperature has dropped below
80 ° C.
Also remember that the moisture conditions of the fabrics must be no more than:
- 50%: for cylinders dryers
The drying Ironer must therefore be used on fabrics that have been centrifuged with a super centrifuge washing
machine. Its purpose is to dry and simultaneously iron the flat garments.
ATTENTION!
When the machine is not running, remember to disconnect all power supplies: electricity and gas, steam,
compressed air.
21. HOW TO USE COOLING
The cool down is a function that allows you to save and optimize the thermal energy accumulated in the machine. When
you are at the end of the work shift, or when you need to stop ironing, you can use such a function. Cooling is turned on
and off by pressing the COOL Down button.
When the function is activated, the thermoregulation is interrupted: the activated cooling signal slides on the display:
The roller continues to spin until the temperature drops below 80°C. Once this temperature is reached, the machine
stops completely.
If it is necessary to reactivate the thermoregulation, the cool down function can be deactivated, before reaching 80 ° C,
by pressing the COOL DOWN button again. In this way, the set point temperature is restored, and the work cycle can
be resumed.
To Next Page
Loading...
