ATTENTION!
If the temperature of the roller is high (above 80°C), continue to insert wet fabrics over the entire length of the
roller, and continue to rotate the roller by hand, to avoid burning of the ironing bands.
Once completed, close the door with the key and wait for the return of the power supply.
When the power supply returns, turn the main switch by placing it on "I". The microprocessor display turns on again
and the machine is placed on standby, waiting for a new start-up command.
ATTENTION!
To make sure that all the personnel who use the machine have well understood the procedure to possibly free a
trapped limb. Perform six-monthly exercises to verify the correct understanding of the procedure.
17. WHAT TO DO IN CASE OF LACK OF ELECTRICITY
If the power supply is lost, it is possible that one or more garments stay inserted between the roller and the ironing
bands risking burning out.
It is also possible that, if the temperature is above 80 ° C, even the ironing bands risk burning.
In this case, follow these steps. Remove the power supply by turning the main switch by placing it on "0".
Use the key, supplied with the documentation, to open the lock of the side door.
Open the door by rotating it on the base
Rotate the flyer:
- counterclockwise: to turn the roller in the direction of ironing and extract the linen stuck
At the same time, insert fabrics with the usual ironing methods, along the entire length of the roller, to lower the
temperature.
ATTENTION!
If the temperature of the roller is high (above 80°C), continue to insert wet fabrics over the entire length of the
roller, and continue to rotate the roller by hand, to avoid burning of the ironing bands.
18. WORK CYCLE: VERIFICATION OF SAFETY SYSTEMS
After turning on the machine, before starting work, it is necessary to check the perfect functioning of the safety devices.
The operator must perform the following procedure each time the machine is started.
To Next Page
Loading...