Immergas Hydro 3 - Page 57

57
4.7 TIMER ON / OFF FUNCTION.
e appliance can be switched on / o using a timer.
Programming to set the programmed ignition (Time On).
- Pressing the “TIME ON” button on the remote control
display shows “SET”, “HOUR” and “ON”.
- At each pulse the switch-on time increases by half an hour.
When the selection exceeds 10 hours, the time will be
increased from hour to hour.
- Once programming is complete, the remote control
transmits the signal to the unit in 0.5 sec.
- Set the time to “0.0” and the automatic switch-on will be
canceled.
Programming to set the programmed shutdown (Time
O).
- Pressing the “TIME OFF” button on the remote control
display shows “SET”, “HOUR” and “ON”.
- At each pulse the switch-o time increases by half an hour.
When the selection exceeds 10 hours, the time will be
increased from hour to hour.
- Once programming is complete, the remote control
transmits the signal to the unit in 0.5 sec.
- Set the time to “0.0” and the automatic switch-o will be
canceled.
Programming to set the programmed power on and o
(Time On / Time O).
- Set the unit on and o by following the steps described
above.
- If the dierence between switch-on and switch-o time
does not exceed 10 hours, stop programming starts half
an hour aer starting the unit.
- If the dierence between switch-on and switch-o time
exceeds 10 hours, stop programming starts one hour aer
starting up the unit.