Immergas VICTRIX PRO V2 EU - Page 34

VICTRIX PRO V2 EU
34
13 SLUDGE REMOVER KIT FOR VICTRIX PRO V2 EU
SINGLE INSTALLATION CODE: 3.033673
Among the wide range of optionals for new VICTRIX PRO
V2 EU generators, Immergas also oers the sludge remover
kit for single installation.
Designed to capture the lth inside the systems as much as
possible, it helps to keep the generator and thermal system
ecient.
It is advisable to insert the sludge remover kit whenever a new
generator is installed in an existing system, so as to prevent
buildups from jeopardising thermal exchange and operation
of the new generators.
Materials.
• Body: brass CW617N - UNI EN 12165
• Filter: stainless steel AISI 304
• Gaskets: EPDM
• Magnet: AlNiCo
Operation:
e ow enters the sludge remover, where it slows down to
promote separation of solid impurities inside the uid. e
solid impurities are separated aer colliding with the metal
mesh (A) and the ferrous materials are held by the force of
attraction generated by the magnet (B).
It is possible to clean the lter without needing to disassem-
ble and/or switch o the system, by opening the interception
cock (C) and removing the magnet (B) from the containment
pocket, pulling it upwards.