How to deal with the smell of gas from Immergas Victrix Tera 28 1?
If you smell gas from your Immergas Boiler, it's likely due to a leakage from the gas circuit pipelines. Immediately check the sealing efficiency of the gas intake circuit to resolve this issue.
What to do if Immergas Victrix Tera 28 1 safety thermostat activates frequently?
If your Immergas Boiler frequently activates the safety thermostat, it could be due to several reasons: 1. **Lack of water:** Ensure the system pressure is within the established limits by checking the pressure gauge. 2. **Poor water circulation:** Verify that the radiator valves are open to allow proper water flow. 3. **Blocked pump:** Check the functionality of the pump to ensure it's circulating water effectively.
Why does my Immergas Victrix Tera 28 1 have repeated ignition blocks?
Repeated ignition blocks in your Immergas Boiler can stem from a couple of issues: * **No gas supply:** Confirm there's pressure in the network and that the gas adduction cock is open. * **Incorrect gas cock adjustment:** Ensure the gas valve is correctly calibrated.
How to fix irregular combustion or noisiness in Immergas Boiler?
Irregular combustion or noisiness in your Immergas Boiler can be attributed to: * A dirty burner. Clean the burner and ensure correct installation of the terminal. * Incorrect combustion parameters. Check the correct setting of the gas valve (Off-Set setting) and the correct percentage of CO2 in the flue gas. * Intake-exhaust terminal not correctly installed. Clean the components and ensure correct installation of the terminal.
How to stop noise due to air in Immergas Victrix Tera 28 1 Boiler system?
If you notice noise due to air in the Immergas Boiler system: * Check the opening of the special air vent valve cap. * Make sure the system pressure and expansion vessel pre-charge values are within the set limits; The factory-set pressure values of the expansion vessel must be 1.0 bar, the value of system pressure must be between 1 and 1.2 bar.
What causes a blocked siphon in Immergas Boiler?
A blocked siphon in your Immergas Boiler might be due to dirt or combustion products deposited inside. To resolve this, check, by means of the condensate drain cap, that there are no residues of material blocking the flow of condensate.
General| Type | Condensing |
|---|---|
| Fuel Type | Natural Gas / LPG |
| DHW Output | 28 kW |
| Heat Exchanger Material | Stainless Steel |
| Protection Rating | IPX5D |
| Dimensions (H x W x D) | 748 x 440 x 256 mm |
| Max working temperature | 90°C |
| Electrical connection | 230 V / 50 Hz |
| NOx Class | 6 |
| Water pressure | 0.3 - 3 bar |
To Next Page
