How to deal with the smell of gas from Immergas Victrix Tera 32 1?
If you smell gas from your Immergas Boiler, it's likely due to a leakage from the gas circuit pipelines. Immediately check the sealing efficiency of the gas intake circuit to resolve this issue.
What to do if Immergas Boiler safety thermostat activates frequently?
If your Immergas Boiler frequently activates the safety thermostat, it could be due to several reasons: 1. **Lack of water:** Ensure the system pressure is within the established limits by checking the pressure gauge. 2. **Poor water circulation:** Verify that the radiator valves are open to allow proper water flow. 3. **Blocked pump:** Check the functionality of the pump to ensure it's circulating water effectively.
Why does my Immergas Victrix Tera 32 1 Boiler have repeated ignition blocks?
Repeated ignition blocks in your Immergas Boiler can stem from a couple of issues: * **No gas supply:** Confirm there's pressure in the network and that the gas adduction cock is open. * **Incorrect gas cock adjustment:** Ensure the gas valve is correctly calibrated.
How to fix irregular combustion or noisiness in Immergas Victrix Tera 32 1 Boiler?
Irregular combustion or noisiness in your Immergas Boiler can be attributed to: * A dirty burner. Clean the burner and ensure correct installation of the terminal. * Incorrect combustion parameters. Check the correct setting of the gas valve (Off-Set setting) and the correct percentage of CO2 in the flue gas. * Intake-exhaust terminal not correctly installed. Clean the components and ensure correct installation of the terminal.
How to stop noise due to air in Immergas Victrix Tera 32 1 system?
If you notice noise due to air in the Immergas Boiler system: * Check the opening of the special air vent valve cap. * Make sure the system pressure and expansion vessel pre-charge values are within the set limits; The factory-set pressure values of the expansion vessel must be 1.0 bar, the value of system pressure must be between 1 and 1.2 bar.
What causes a blocked siphon in Immergas Boiler?
A blocked siphon in your Immergas Boiler might be due to dirt or combustion products deposited inside. To resolve this, check, by means of the condensate drain cap, that there are no residues of material blocking the flow of condensate.
Information specific to the installation professional.
Guidance for the end-user.
Procedures for maintenance personnel.
Safety and compliance advice for installers.
Safety and usage advice for users.
Safety and procedural advice for technicians.
Guidelines and requirements for boiler placement.
Procedure for ensuring correct condensate trap filling.
Required clearances for safe boiler installation.
Adapting the boiler for low-temperature systems.
Data on flue system component resistance.
Correct placement of flue system gaskets.
Connecting flue system extensions and elbows.
Flue installation within a recessed frame.
Instructions for assembling the protective cover kit.
Direct air intake installation in recessed frames.
Maximum allowable length for exhaust pipes.
Boiler heat output specifications.
Safety precautions before maintenance or initial setup.
Steps for commissioning the boiler after installation.
Adjusting fan speed for optimal CO₂ at low output.
Adjusting fan speed for optimal CO₂ at high output.
Step-by-step guide to PCB programming.
General| Type | Condensing Boiler |
|---|---|
| Power Output | 32 kW |
| Fuel Type | Natural Gas / LPG |
| Energy Efficiency Class Heating | A |
| Energy Efficiency Class DHW | A |
| Water Pressure | 0.5 - 3 bar |
| Max Working Temperature | 85°C |
| Ignition | Electronic |
| Noise Level | 49 dB |
To Next Page
