section is not present, then Windows is
not recognizing the device. All cables
should be removed; then only the USB
cable should be plugged back in.
If the status in the Device Manager
doesn’t change, shut down the computer
and unplug the USB cable from the
computer. Power on the system again
and then plug in the USB cable.
If Windows still doesn’t recognize the
device, try “Scan for new Devices” from
the Windows Device Manager.
MicroScribe is
transmitting
inaccurate data.
Mis-initialized MicroScribe. Be sure to follow all MicroScribe initial
configuration procedures in Chapter 2.0 of
this manual.
Mis-configured software Please check with the software
documentation provider to ensure proper
use.
Incorrect stylus tip If you are using multiple tips, make sure
that you started the unit with the correct
tip and followed tip replacement
procedures.
Possible radio or
television
interference
Improperly set-up
MicroScribe system.
Turn the television or radio antenna until
the interference stops.
Move the television or radio farther away
from the interfering device.
Use only shielded cables to connect the
MicroScribe to it's attachments.
Plug the interfering device into an outlet
that is on a different circuit than the radio
or television.
To Next Page
Loading...