G.
L.
Fig. 13 Fig. 14
Fig. 11 Fig. 12
Fig. 15
• Separate the front
cover 501 and the
power rotor 1020.
K. xTx x
• Place the front cover 501 on a pair of wood-
en pieces.
• Press out the shaft seal, stationary member
with a suitable tool.
• Loosen the shaft seal rotating member.
• Remove and inspect the
idler rotors 202.
I.
• Remove the secondary seal 125 with a
suitable screw driver.
Fig. 16
H. xTxx
501
• Insert two suitable
screw drivers in
the carrier S5 slots
and gently push the
rotating member
S4, S7 off the rotor
shaft.
• Loosen the two
stop screws S8
(3 mm Allen key)
on the carrier S5
and pull it off.
xVxx
xTxx
xQxx
J. xVxx
Rotating
Member
S5
S8
Product Specification Sheet
X-Cel House, Chrysalis Way, Langley Bridge, Eastwood, Nottinghamshire NG16 3RY
Tel: +44 (0) 1773 302 660 | Email: sales@northridgepumps.com | Website: www.northridgepumps.com
To Next Page
Loading...
