PC-POD-CP-010-v01 Printed copies are not controlled. Page 11 of 14
3. Restart your computer to allow the adapter to be fully installed.
4. Once your computer has restarted insert your ImpediMed software CD-Rom
into your computers CD-Rom drive.
5. Select your language.
6. Click the Set up the USB Ethernet adapter button.
7. This window will display all USB-Ethernet adapters that have been installed on
your computer. Click the USB to fast Ethernet converter inside the network
adapters found window and click the Next button to start auto-configuring
your USB-Ethernet converter.
8. Click the Finish button to continue the auto-configuration.
9. Click the OK button and restart your computer when the above prompt
window appears to finalize the USB-Ethernet adapter setup.
Step 2: Installing your BioImp software:
1. Once your computer has restarted re-insert your ImpediMed software CD-Rom
into your computers CD-Rom drive.
2. Select your language.
3. Click the Install “BioImp” button.
4. Click the “Next” button to continue or “Cancel” to exit the software setup.
5. Click the Yes button to accept the software license agreement and continue with
installation and follow the onscreen instructions to finish installation of your
software.
Step 3: Connecting your SFB7 device to your PC:
1. Turn off your SFB7 and shutdown your PC.
2. Attach the RED Ethernet crossover cable from your device to your PC.
3. Turn on your PC and once the PC is booted turn on your Imp SFB7 device.
4. Your PC will now detect the new network connection and you are ready to
upload files from the SFB7 to your software or computer.
NOTE: BIS and SFBI measurement data is stored on board, but only BIS measurement
data is retrievable via Ethernet.
NOTE: Uploaded files are automatically deleted from the Imp SFB7. Sophisticated file
transfer ensures that each file is transferred, confirmed as received, before deletion.
To Next Page
