PC-POD-CP-010-v01 Printed copies are not controlled. Page 13 of 14
12.2 Care and Maintenance
12.2.1 Care of the product:
12.2.1.1 When in use always keep the SFB7 in the carry
case.
12.2.1.2 Clean the SFB7 with a dry, clean cloth only.
12.2.1.3 Avoid exposure to water, impact and excessive
heat or direct exposure to sunlight.
12.2.2 Care of the leads:
12.2.2.1 Clean leads with a damp cloth if required.
12.2.2.2 Wherever possible leads should remain connected
to the device.
12.2.2.3 Unnecessary removal of the leads from the device
may reduce lead life.
12.2.2.4 Ensure that the lid of the case does not close on
the leads.
12.2.2.5 Do not wind the leads tightly, crinkle, or twist the
leads, as this may cause the fine wires inside to break.
12.2.2.6 If the leads appear to be damaged, contact
ImpediMed or a licensed distributor for replacements.
12.2.3 Care of the electrodes:
12.2.3.1 The electrodes are for single use. Please discard
after use.
12.2.3.2 Reseal the electrode pouch after use.
12.2.3.3 Unused electrodes should remain in the supplied
pouch and in a cool dry place to prevent electrode gel
from dehydrating.
12.2.3.4 Use by expiry date.
12.2.3.5 Do not use an electrode if the conductive adhesive
is dry and no longer pliable or sticky. This may result in
inaccurate measurements.
12.2.4 Care of the touch screen:
To Next Page
Loading...
