RShell Reference Manual
Revision 4.2, Copyright © 2009, Impinj, Inc. Proprietary and Confidential 21
Timeout <timeout> integer Configure the timeout (in seconds) for LLRP reader-
initiated connections before declaring failure. If the TCP
handshake has not completed within this timeout period,
the next server will be tried, subject to the geometric
back-off. For example, for a high-latency WAN, one could
tune this variable higher so that the reader waits longer
for the handshake to complete before giving up on the
connection attempt. A failed connection will invoke the
retry timer (see retry command entry).
4.2.6 Config SNMP Command
The
config snmp menu allows the user to configure the SNMP settings for the reader. The config
snmp command parameters are shown in Table 4-19.
Table 4-19 Config SNMP Command Parameters
Command Description
service Enable/Disable the SNMP service.
access Sub-menu of access specific commands.
write Sub-menu of write specific commands.
epcg Sub-menu of EPCglobal RM MIB specific commands.
4.2.6.1 Config SNMP Service Command
Table 4-20 shows the
config snmp service parameters.
Table 4-20 Config SNMP Service Command Parameters
Command Argument Format Description
service [enable | disable] enum Globally enable/disable the SNMP service. When the
service is enabled, it will be started and when it is disabled
it will be stopped. If the service is enabled when the system
boots, the SNMP service will be started.
Example to enable the service:
> config snmp enable
Status='0,Success'
4.2.6.2 Config SNMP Access Command
The
config snmp access command allows the user to configure the SNMP read and write access
settings for the reader. The config snmp access command parameters are shown Table 4-21.
To Next Page
Loading...