RShell Reference Manual
22. Proprietary and Confidential Revision 4.2, Copyright © 2009, Impinj, Inc.
Table 4-21 Config SNMP Access Command Parameters
Command Argument Format Description
rocommunity <read-only string> string Sets the read-only community string for read access to
SNMP attributes.
rwcommunity <read-write string> string Sets the read-write community string for read-write
access to SNMP attributes. If SNMP writes are
disabled this string may still be used to read via SNMP.
Example to set the rocommunity string to “my-read-only-password”:
> config snmp access rocommunity my-read-only-password
Status='0,Success'
4.2.6.3 Config SNMP Write Command
The
config snmp write command allows the user to configure whether SNMP writes are allowed
(enabled) or not (disabled). The config snmp write command parameters are shown in Table
4-22Table 4-21.
Table 4-22 Config SNMP Write Command Parameters
Command Argument Format Description
enable all string Enable SNMP writes on all writeable objects.
disable all string Disable SNMP writes on all writeable objects.
Example to enable SNMP writes:
> config snmp write enable all
Status='0,Success'
4.2.6.4 Config SNMP EPCG Command
The
config snmp epcg menu provides control of the EPCglobal RM MIB. There are no direct
subcommands and only one submenu, device, for this command.
4.2.6.4.1 Config SNMP EPCG Device Command
The
config snmp epcg device command is used to configure epcg device settings. Currently, the
device role is the only settings that can be configured. The config snmp epcg device command
parameters are shown in Table 4-23.
To Next Page
Loading...