impinj RShell - Show RFID LLRP Commands

RShell Reference Manual
Revision 4.2, Copyright © 2009, Impinj, Inc. Proprietary and Confidential 41
filters, but the write failed; <n> is 1–4
Antenna<n>LockCount Integer Number of tags locked at Antenna <n> that matched
the configured filters; <n> is 1–4
Antenna<n>FailedLockCount Integer Number of tags where a lock was attempted at
Antenna <n> because the tag matched the configured
filters, but the lock failed; <n> is 1–4
Antenna<n>KillCount Integer Number of tags killed at Antenna <n> that matched the
configured filters; <n> is 1–4
Antenna<n>FailedKillCount Integer Number of tags where a kill was attempted at Antenna
<n> because the tag matched the configured filters,
but the kill failed; <n> is 1–4
Antenna<n>EraseCount Integer Number of tags erased at Antenna <n> that matched
the configured filters; <n> is 1–4
Antenna<n>FailedEraseCount Integer Number of tags where a erase was attempted at
Antenna <n> because the tag matched the configured
filters, but the erase failed; <n> is 1–4
Gpi<n>TransitionCount Integer Number of times a GPI event matched the
configuration; <n> is 1–4
4.3.4.2 Show RFID LLRP Commands
The
show rfid llrp command provides statistics on the LLRP interface and has the subcommands
listed in Table 4-49.